<<<DIMENSION SCREWLESS                                                                                           

Instructions for Fitting

Dimension Screwless Accessories                                              

1.        After removing from

packaging place the product

face down onto a soft cloth

or towel. Remove the

decorative front plate by

inserting the tip of a

screwdriver into one of the

short slots (see diagram)

so the screwdriver is

between the inside edge

of the decorative plate and

the outer edge of the clear

plastic. Apply gentle

pressure and twist the

screwdriver one quarter

turn (as shown).

 

Lift out switch assembly
2.        Ensure wall is flat around wall box removing any lumps of plaster and sanding away any uneven plaster.

3.    Connect wires to

appropriate terminals on

rear of switch assembly

including the earth wire to

the earth terminal on the

metal back plate.

4.    Use fixing screws

provided to fix switch

assembly onto wall box.

Tighten screws evenly a

little at a time until just

tight enough to prevent

movement of the back plate.

Do not over-tighten.

5.     Pick up decorative front plate carefully and push into place, pressing gently on each side to ensure the front plate has engaged with the plastic clips on the switch assembly.

N.B. (If the decorative front plate needs to be removed at any time (eg. during decorating) place the tip of a screwdriver into one of the slots on either side of the product (adjacent to the wall) and gently rotate screwdriver until clip releases front plate taking care not to let the front plate fall onto floor.)

 

Home